MIL-T-43238C
number of shipping containers in the inspection lot. The inspection level
shall be S-2 and the AQL, expressed in terms of defects per hundred units,
shall be 4.0.
Examine
Defect
Marking (interior
omitted; incorrect; illegible; of improper size,
and (exterior)
location, sequence, or method of application
Any component missing, damaged, defective, or not as
Materials
specified
Workmanship
Components not snug fit in container (loose);
incomplete or improper application of tape, tie cord,
corrugated fiberboard, or shroud; inadequate
blocking, bracing, strapping, or nailing
4.4.5 End item testing. Each table shall be tested as specified on Drawing
11-1-328 to determine compliance with 3.4. Any nonconforming table shall be
rejected.
5. PACKAGING
5.1 Preservaiton. Preservation shall be level A or Commercial, as
specified (see 6.2).
5.1.1 Level A. The feet shall be screwed, full depth, on to each leg of
the inspection table. The legs shall be folded flat against the underside of
the table and immobilized by securing with cord or twine having a minimum
breaking strength of 100 pounds, or tape conforming to PPP-T-97. The
electrical plug and outlet shall be sealed with -tape conforming to A-A-884.
The free end of the electrical extension cord shall be secured to the table
with tape, cord or twine. The fluorescent lamps shall be securely mated to
their respective lampholders and the table top set in place. The table top
shall then be completely covered with a sheet of corrugated fiberboard
conforming to type CF, class domestic, variety SW, grade 200 of PPP-F-320.
The fiberboard shall be secured with three girth-wise ties of tape, cord or
twine located one at the center and the and the others approximately 18 inches
in from each end of the table.
5.1.2 Commercial. Each shadow table shall be preserved in accordance with
ASTM D 3951.
5.2 Packing. Packing shall be level A, B, of Commercial as specified (see
6.2).
5.2.1 Level A packing. Each inspection table, preserved as specified in
5.1, shall be packed in a snug-fitting shipping container conforming to
overseas type, style A or 1, grade A, type 3 load of PPP-B-601; or class 2,
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business