MIL-T-43238C
3.5.1 Special marking. An information plate containing the data specified
on Drawing 11-1-328 shall be permanently affixed to the table. Marking method Marking method
shall produce permanent and durable markings.
3.6 Workmanship. The workmanship shall confirm to the quality established established
by this document.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwixe specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified, in the contract or purchase order, the contractor may use his own
or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth in
the document where such inspections are deemed necessary to assure supplies
and services conform to prescribed requirements.
4.1.1 Cerificate of compliance. Where certificates of compliance are
submitted (see 6.3), the Government reserves the right to check test such
items to determine the validity of the certification.
*
4.2 Classification of inspection. The inspection requirements specified
herein are classified as follows:
First article inspection (see 4.3).
b.
b. Quality conformance inspection (see 4.4).
*
4.3 First article inspection. When a first article is required (see 6.2),
it shall be examined for the defects specified in 4.4.3 and 4.4.4 and tested
as specified in 4.4.5. The presence of any defect or failure of any test
shall be cause for rejection of the first article.
4.4 Quality conformance inspection. Unless otherwise specified, sampling
for inspection shall be performed in accordance with MIL-STD-105.
4.4.1. Component and material inspection. In accordance with 4.1,
components and materials shall be inspected in accordance with all the
requirements of referenced documents unless otherwise excluded, amended,
modified, or qualified in this document or applicable purchase document.
4.4.2 In-process inspection. Inspection shall be made at appropriate
stages of fabrication to determine conformance to the construction require-
consideration for acceptance any material for which in-process inspection has
indicated nonconformance.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business