MIL-P-44247(GL)
TABLE I. End item visual defects (cont'd)
Classification
Examine
Defect
Major
Minor
Webbing or tape
Ends of webbing not as required,
x
(cont'd)
Frayed or scalloped edges not firmly
or tightly woven.
x
Hardware - general
Broken or malformed; corroded area;
burrs or sharp edge,
x
Finish omitted or not as specified.
x
Any required component improperly
installed causing failure to serve
intended purpose.
x
Seams and stitchings
Open seams:
- 1/2 inch or less,
x
- more than 1/2 inch.
x
NOTE :
A seam shall be classified as an open
seam when one or more stitches joining
a seam are broken, or when two or more
consecutive skipped or runoff stitches
occur,
Raw edge (on edge
More than 1/2 inch in length when
required to be
securely caught in stitching.
x
finished)
NOTE :
Raw edge not securely caught in stitch-
ing shall be classified as an open seam.
Seam and stitch type
not specified seam or stitch type,
x
Seam twisted, pleated of badly puckered
(unless otherwise classified herein).
x
Any line of stitching not beginning
or ending where specified (unless other-
wise classified herein).
x
Any seam not lapped or finished as
specified.
x
Stitch tension
Tension loose, resulting in loos bobbin
or top thread.
x
Tension tight, resulting in puckering of
material,
x
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business