MIL-DTL-40137F
3.8 Workmanship. All components and assemblies of the rigging clevises shall be free
of any rust or corrosion, dirt, and other foreign matter. External surfaces shall be free from sharp
edges or burrs. Components shall not be fractured, cracked, buckled, loose, dented, missing,
malformed, or misaligned.
4. VERIFICATION
4.1 Classification of inspection. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. When required (see 6.2), examination of the first article
samples for defects shall be as specified in 4.3.2 and 4.3.3 and testing of the first article samples
for proof load shall be as specified in 4.4.1. The presence of any defect or failure of the proof
load test shall be cause for rejection of the first article.
4.3 Conformance inspection. Unless otherwise specified (see 6.2), sampling for
conformance inspection shall be performed in accordance with MIL-STD-1916. The level of
inspection shall be as specified (see 6.2).
4.3.1 Inspection of materials and components. Components and materials used shall be
inspected in accordance with all the requirements of the applicable standard unless otherwise
specified in the acquisition order (see 6.2).
4.3.2 End item visual examination. The end item shall be examined for the defects listed
in table I. The lot size shall be expressed in units of clevises.
TABLE I. End item visual defects.
Classification
Examine
Defect
Major
Minor
Finish, protective Any breaks through coating to metal
101
102
Any area of rust or corrosion
201
Dirt, oil, grease, or other foreign matter
Design
Not specified type or size
103
Any departure from design indicated on applicable
104
document (not otherwise classified herein)
Construction and Any component missing
105
workmanship
Any component cracked or fractured
106
Any operation omitted or not performed as specified
107
Any sharp edges, burrs, or metal slivers
108
Any part not assembled or joined as specified
202
Any surface roughness exceeding specified limit
203
Identification
Missing, illegible, incomplete, incorrect, not
marking
permanent
204
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business