MIL-P-44115B
4.4.5 Palletization examination. The fully packaged and palletized end
items shall be examined for the defects listed below. The lot size shall be
expressd in units of palletized unit loads. The sample unit shall be one
palletized unit load, fully packaged. The inspection level shall be S-1 and
the AQL, expressed in terms of defects per hundred units, shall be 6.5.
Defect
Examine
Length, width, or height exceeds specified maximum
Finished dimensions
requirements.
Pallet pattern not as specified.
Palletization
load not bonded with required straps as specified.
Exceeds maximum load limits.
weight
Omitted; incorrect; illegible; of improper size,
Marking
location, sequence, or method of application.
5. PACKAGING
5.1 Preservation shall be level A.
5.1.1 Main panel, rear panel
or nose burner and hardware assembly.
Hardware components for the main
panel, rear panel or nose bumper, of the
type and quantity specified in
Wining 11-1-2780, Shall be packaged in
plastic bags conforming to type
I or II, style 1, 4 or 5, minimum thickness
0.004 inch, of PPP-B-26.
5.1.2 Extraction bracket and hardware assembly. Hardware components of
the type and quantity specified in Drawing 11-1-2780, shall be packed in
plastic bags conforming to type I or II, style 1, 4 or 5 minimum thickness
0.004 inch, of PPP-B-26.
5.1.3 EFTA bracket and hardware assembly. Inside and outside bracket and
hardware components of the type and quantity specified in Drawing 11-1-2780,
shall be packaged in plastic bags conforming to type I or II, style 1, 4 or
5, minimum thickness 0.004 inch, of PPP-B-26.
5.1.4 Tandem link or suspension link and hardware assembly. Hardware
components for the tandem link or suspension link shall be packaged in
plastic bags confirming to type I or 11, style 1, 4 or 5, minimum thickness
0.004 inch, of PPP-B-26. Each tandem link or suspension shall be completely
-
wrapped in 50-pound basis weight kraft paper conforming to A-A-203.
5.1.5 Clevis and hardware assembly. Each clevis and its hardware shall be
packagd in plastic bags conforming to type I or II, 1, 4 OR 5, MINIMUM
thickness 0.004 inch, of PPP-B-26.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business