MIL-DTL-44477A(GL)
3.3.4.2 Dip method. Coat the wire rope end with a nylon II or nylon 6/6 powder. Heat the
coated end for 10 seconds at 405 ± 15°F using either an induction coil (2 to 4-inch) with an
automatic timer control or an electric melting pot with an automatic temperature control (see
6.3).
3.4 Replacement of defective components. During the spreading, cutting and manufacturing
process, components having material defects or damages that are classified as defects in table I
shall be removed from production and replaced with nondefective and properly matched
components.
3.5 Repairs. Repairs such as mends, darns, patches, or splices are not permitted on the
container.
3.6 Workmanship. The finished and assembled containers shall conform to the quality of the
product established by this specification.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.2)
b. Conformance inspection (see 4.3)
4.2 First article inspection. When a first article inspection is required (see 3.1 and 6.2) it
shall be examined in accordance with 4.3. Sampling for first article inspection shall be as
specified in the contract or purchase order (see 6.2).
4.3 Conformance inspection. Conformance inspection shall include the examination of
4.3.1, 4.3.2, 4.3.3 and 4.3.4. Sampling for the inspections in 4.3.3 and 4.3.4 shall be as specified
in the contract or purchase order (see 6.2).
4.3.1 Component and material inspection. Components and materials shall be inspected in
accordance with all the requirements of referenced documents unless otherwise excluded,
amended, modified, or qualified in this specification or applicable purchase document.
4.3.2 In-process inspection. Inspection of subassemblies shall be made to ascertain that
construction details and dimensional requirements which cannot be examined in the finished
product are in accordance with specified requirements. The Government reserves the right to
exclude from consideration for acceptance, any material or service for which in-process
inspection has indicated nonconformance.
4.3.3 End item visual examination. The end items shall be examined for visual defects.
Each noncompliance shall be scored as a defect in accordance with table I.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business