MIL-DTL-44033B
3.3 Materials. The materials used in the manufacture of the
lines shall conform in all aspects to the requirements specified
on the drawings and parts lists pertaining thereto, and as
specified herein. Recovered materials shall be used to the
maximum extent possible.
3.4 Construction. Construction shall conform to all aspects of
the requirements specified on the drawings and as specified
herein. Repairs to defective stitching shall be as specified
herein. Other repairs or rework shall not be performed on the
lines.
3.4.1 Webbing relaxation. All webbing used in the fabrication
of loops shall be relaxed for a minimum of 48 hours prior to
measuring for cutting. Relaxation of the webbing shall be
accomplished by loosening the coiled rings so there is a minimum
of 1/4 inch space between the webbing coils of the roll.
3.4.2 Dimensions. Finished lengths and the number of loops for
the lines shall be as specified in the contract (see 6.2). The
cut length of the individual loops, after relaxation of the
webbing rolls (see 3.4.1) and prior to splicing, shall be
determined by the contractor and shall result in the finished
length shown on the drawings.
3.4.3 Machine stitching. Ends of stitching shall be back
stitched not less than 1/2 inch. Thread tension shall be
maintained so there will be no loose stitching and the locks
shall be embedded into the materials sewn. all thread ends shall
be trimmed so that they do not exceed 1/4 inch.
3.4.3.1 Automactic Stitching. Automatic sewing machines may be
used to perform any of the stitch patterns provided the
requirements for the stitch pattern, stitches per inch, size and
type of thread are met; and at no less than two tying,
overlapping or backstitches are used to secure the ends of the
stitching.
3.4.3.2 Loose stitches. Looses stitches shall not be removed
but shall be reinforced by adjacent stitching.
3.4.3.2 Tight stitches. Tight stitches which occur on the
sliding keeper only shall be removed and the section shall be
restitched.
3.4.3.4 Repairs of the 301 stitching. Repairs of type 301
stitching shall be as follows:
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business