MIL-R-1832D
(Non-Government standards and other publications are normally available from
the organizations that prepare or distribute the documents. These documents
also may be available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, suspersedes applicable laws and
regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to
first article inspection (see 6.3), in accordance with 4.3.
3.2 Material.
3.2.1 Natural rubber. The type I and type II bands shall be made from
natural rubbers suitably compounded and steam cured. It is encouraged that
recycled material be used when practical as long as it meets the requirements of
this specification.
3.3 Physical requirements. Type I and type II rubber bands shall conform to
the physical requirements specified in table I, when tested as specified in
4.4.4.
TABLE I. Physical requirements
Type II
Type I
Property
Permanent set, percent (maximum) (after 500 + 50
15
20
percent elongation for 10 minutes)
Breaking force, pounds (minimum)
45
Initial
1/
After aging
Ultimate elongation, percent (minimum)
650
700
Initial
1/
1/
After aging
300
390
Weight (minimum), bands/pound
1/ Shall be not less than 75 percent of the initial figure.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business