MIL-PRF-27260D
4.
VERIFICATION
4.1
Classification of inspections.
The inspection requirements specified herein are classified as follows:
a.
Qualification inspection (see 4.2).
b.
Conformance inspection (see 4.3).
4.1.1 Sampling for inspection.
Unless otherwise specified, sampling shall be in accordance with ANSI/ASQ Z1.4.
4.2
Qualification inspection.
Qualification inspection shall be performed on three complete tie down assemblies (A, B, and C).
The three tie down assemblies will be visually examined as specified in 4.6. The three complete
tie down assemblies will then be subjected to the tests as specified in 4.7, in accordance with the
sequence specified in Table I (see 4.7).
TABLE I. Testing sequence.
Test Paragraph
Test Article A
Test Article B
Test Article C
4.7.1 4.7.1.3
1
4.7.1.2
6
4
4.7.1.3
7
5
4.7.2 (strap only)
6
4.7.3.1
2
4.7.3.2
5
4.7.3.3
3
4.7.3.4
4
4.7.3.5
1
4.7.3.6
2
4.7.3.7
3
4.7.3.8
2
4.7.4
3
4.7.4.1
4
4.7.5
1
4.3
Conformance inspection.
Conformance inspection shall include the inspections (see 4.6) and the tests as specified in 4.7.1
to 4.7.1.3.
4.4
Test conditions.
Unless otherwise specified, all inspections shall be performed in accordance with the test
conditions specified in RTCA/DO-160 for the applicable test.
4.5
Requirements cross-reference matrix.
Table II provides a cross-reference matrix of the Section 3 requirements tested or verified in the
paragraphs below.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business