MIL-DTL-6458 Chain Assemblies, Single Leg, Aircraft Cargo Tie DownThis specification covers two types of flight safety critical aircraft cargo tie down chain assemblies. The chains described in this specification are to be used in conjunction with the tie down tensioners described in MIL-DTL-25959, where the Type I chain assembly is to be used with the Type I \(styles A and B\) and Type III tie down tensioners, and the Type II chain assembly is to be used with the Type II \(styles A and B\) and Type IV tie down tensioners.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20

MIL-DTL-6458G

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this

specification. This section does not include documents cited in other sections of this specification

or recommended for additional information or as examples. While every effort has been made to

ensure the completeness of this list, document users are cautioned that they must meet all

specified requirements documents cited in sections 3 and 4 of this specification, whether or not

they are listed.

2.2 Government documents.

2.2.1 Specification, standards and handbooks. The following specifications, standards,

and handbooks form a part of this document to the extent specified herein. Unless otherwise

specified, the issues of these documents are those cited in the solicitation or contract.

DEPARTMENT OF DEFENSE STANDARDS

MIL-STD-130

- Identification Marking of U.S. Military Property.

MIL-STD-810

- Environmental Engineering Considerations and Laboratory

Tests.

MIL-STD-889

- Dissimilar Metals.

(Copies of these documents are available at https://assist.dla.mil/quicksearch or

https://assist.dla.mil or from the Standardization Documents Order Desk, 700 Robbins Avenue,

Building 4D, Philadelphia, PA 19111-5094.

2.3 Non-Government publications. The following documents form a part of this

document to the extent specified herein. Unless otherwise specified, the issues of these

documents are those cited in the solicitation or contract.

ASTM INTERNATIONAL

ASTM A 304

- Standard Specification for Carbon and Alloy Steel Bars Subject

to End-Quench Hardenability Requirements.

ASTM A 322

- Standard Specification for Steel Bars, Alloy, Standard Grades.

ASTM A 108

- Standard Specification for Steel Bars, Carbon and Alloy,

Cold-Finished.

ASTM C150/C150M- Standard Specification for Portland Cement

ASTM C 778

- Standard Specification for Standard Sand

(Copies of these standards may be found online at https://www.astm.org/ or from: ASTM

International, 100 Barr Harbor Drive, P.O. Box 700C, West Conshohocken PA 19428-2959.)