INCH-POUND
MIL-DTL-27893F (GL)
07 April 1997
SUPERSEDING
MIL-H-27893E
10 April 1989
DETAIL SPECIFICATION
HARNESSES, PARACHUTIST'S INDIVIDUAL EQUIPMENT PACK
("H"- TYPE)
This specification is approved for use by the Natick Research, Development, and
Engineering Center, Department of the Army, and is available for use by all Departments and
Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers one type of general purpose harness, having an "H"
design and made of nylon webbing. The harness is equipped with quick-fit adapters, buckles and
snaps to secure it around the load and to a parachute harness worn by the parachutist.
1.2 Classification. The harness shall be of the following type:
Type I - Deleted (see 6.3)
Type II - Harness, Single Point Release
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has
Beneficial comments (recommendations, additions, deletions) and any pertinent data which
may be of use in improving this document should be addressed to: U.S. Army Natick
Research, Development, and Engineering Center, Attn: SSCNC-UTE Natick, MA 01760-
5017 by using the self-addressed Standardization Document Improvement Proposal (DD
Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 1670
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business