INCH-POUND
MIL-DTL-44475A (GL)
9 September 1996
SUPERSEDING
MIL-R-44475 (GL)
8 November 1993
DETAIL SPECIFICATION
RELEASE, PARACHUTIST'S INDIVIDUAL EQUIPMENT
This specification is approved for use by the Natick Research, Development, and Engineering
Center, Department of the Army, and is available for use by all Departments and Agencies of the
Department of Defense.
1. SCOPE
1.1 Scope. This specification covers one type of a fabric release assembly.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirements documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
2.2 Government documents.
2.2.1 Drawing. The following Government drawing forms a part of this document to the
extent specified herein. Unless otherwise specified, the issue is that cited in the solicitation.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which
may be of use in improving this document should be addressed to: Commander, U.S. Army
Natick Research, Development, and Engineering Center, Attn: SSCNC-UTE Natick, MA
01760-5017 by using the self-addressed Standardization Document Improvement Proposal
(DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 1670
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business